1989 4x4 Bronco build We picked this project up from someone who started it 10 years ago and had most of the casework done along with the front suspension done. It had lots of surface rust so we stripped down and had soda blasted then painted. The front has cut and turned stock length beams that has 18" of working travel with dana 44 4x4 and stock steering. Rear has solo motorsports links which we made custom mounts for and lengthened the wheel base 2", rear has 24" of travel, also with sway bar Front shocks Fox 2.5 14" co and 3.5 5 tube Fox bypass rear shocks Fox 16" 2.5 co and 18" Fox 3.5 5 tube bypass and 2.0 bump stops motor 351 windsor trans c6 Motor wiring was completely redone by SmithRacewire and used a Mustang Ho computer Front and rear fiberglass bettery relocated bucket seats front and bench seat rear with 5point harnesses holds 4 people The vehicle is caged from to rear with 1.75" chromoly tubing The rear is tubbed with lots of custom sheetmetal work It is currently running 35" General Grabbers on KMC wheels Custom rear bumper holds 35" tire and 10 gal of gas on a swing gate with storage compartment under that holds jack and tools. PCI rade radio and intercomm Rigid lights